Cement based coarse repairing mortar with a high ration of polymer additives and high adherence. A smooth and water tight surface is obtained, without any cracks or peeling.


 

Gross concrete, prefabricated concrete, light concrete for repairing thorn surfaces with widths higher than 4 cm. and cracks with widths higher than 1 cm. For repairing facades, ceiling and wall plasters For repairing broken edges, corners and prefabricated concrete components For obtaining smooth surfaces under ceramic, tiles, granite and other cladding material, or as repair and filling material  For repairing cement based plaster.
 

1. Application surface must be free of all dust, paint, grease etc.
2. Cracks and broken parts on concrete surfaces must be removed, and cleaned until a proper surface is obtained.
3. Swollen surfaces of cement based plaster must be cleaned, cracks and holes, if any, must be repaired.
4. Surface of application must be humidified by water if necessary.
 

 1. 25 kg. of Betox Repairing Mortar-Coarse is mixed by adding 5 to 6 lt of water with a low speed mixer, until it reaches a paste-like appearence.
 2. The Betox Repairing Mortar-Coarse is left to rest for 5 minutes, mixed again to ensure homogeneity and applied on the prepared
surface using a steel trowel.
 3. If the applicatıon thickness exceeds 1.5-2 cm, there must be 24 hours between every coat, and the coat underneath must be humidified.
 4. In hot weather, the surface must be irrigated with certain intervals for 3 days, depending on the weather conditions.
 5. On wide surfaces the smoothness of the surfaces may be ensured using screed trowels.
 

1. Using gloves is recommended during use.
2. As the product is cement based, it must not be inhaled, and rinsed with water in case of contact with skin or eyes.
3. Do not use any other additives when preparing Betox Repairing Mortar-Coarse.
4. It must be stored under dry conditions stacking 10 vertical rows at most.
5. Do not use onto gypsum plaster and gypsum board surfaces.