Cement based, mineral origined ready satin ready plaster with polymer additives;
A washable product that gives a smooth surface ready for painting.

 

Interior and Exterior; gross concrete surfaces and Sıvax-Coarse, Sıvax-Single layer and Sıvax-Fine used surfaces after trifling or strike board application.
 

1. Sıvax Satin should be applied at least 24 hours after previous plaster applications.
2. Surface must be moistured by using water before application.
3. 25 kg Sıvax Satin Ready Plaster is mixed with 5-6 lt of water with a low speed mixer until a homogenous mixture without lumps are obtained, the mortar is left to rest for 2-3 minutes and mixed again to ensure homogeneity.
4. The mortar is applied on the previous plastered surface using a steel trowel max 1-3 mm thickness.
5. Sıvax Satin Ready Plaster is applied two phases to the surface as Satin Coarse (Number 40) and Satin Fine (Number 10)

Cure; For higher robustness of the plaster, surface should be irrigated starting from the 3rd hour after application, for 3 days by determined time moments according to the weather conditions.
 

1. As it is a cement-based material mustn't be directly inhaled. In case of an eye-touch must be washed by ample water.
2. No foreign material can be added into the product.
3. Shouldn't be applied onto frozen surfaces under cold weather conditions.
4. Must be protected against fast drying under severe wind or strong sunlight conditions.
5. Ambient temperature is between +5 °C and +35 °C.