Powder hardener applied on fresh concrete surfaces, containing hydraulic binder (cement) and special natural minerals.

 

Flooring applications for residences, commercial and industrial buildings, garages and car parks, warehouses and sidewalks, loading and unloading surfaces of factories.
 

1. The concrete on the surface where Betox Surface Hardener will be applied must not contain more than 3% air.
2. There must not be any perspiration or segragation on the concrete, and the concrete must not contain micro silica.
3. The concrete surfaces must be leveled, and vibrated.
4. The water-cement ratio of the concrete must be at least 0.45.
5. Sponge type absorbents must not be used on the surfaces.
 

1. Depending on surrounding and the weather conditions, the laying must start after the  concrete sets sufficient to prevent sinking, however, allowing a foot print of 0.5 to 1.5cm depth,
2. Two thirds of the Betox Surface Hardener to be used is spread on the concrete by hand or material spreader,
3. The material is left to humidify, and the material is absorbed onto the surface using flat screed,
4. Remained material is spread to the surface and the same proces is occured.
5. The surface is leveled using steel trowels, or a screed machine.
6. After completion, the surface must be cured using appropriate material, and crack inspection joints must be cut and filled
with adequate material.
 

1. Using gloves is recommended during use.
2. As the product is cement based, it must not be inhaled, and rinsed with water in case of contact with skin or eyes.
3. Do not use any other additives when preparing BETOX Surface Hardener.
4. It must be stored under dry conditions stacking 10 vertical rows at most.